I need to know how can I separate the call type of the task when the calls are within a Inter-cluster. For example: when I make a call from CM A, where are a Inter-cluster Trunk with CM B, the call type of the task in WebView (ICM) comes as "OUT" insted of "IN".
PS.: In the Trunk on CM, the Call Classification was set as OnNet, and in the Route Pattern too.
It is when agent make a call to another CM in the cluster. The problem is that in the WebView Reporting when the agent make an internal call (but to another CM in the cluster) and when he/she make an external call it is classificated as the same CallType, and I need separate it.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...