Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Call Flow

I have following setup.

Cisco 3745 router is integrated with PBX on E& M ports.And I have Cisco Call manager 4.0 in my network.

The problem I am facing is that I am able to make call to analog i.e PBX extensions but analog is not able to make a call to IP phones despite call is landing on 3745 but is not routed to CCM.

Thanks

1 REPLY
New Member

Re: Call Flow

Are you using H.323 or MGCP on your 3745? If H.323, make sure you have a dial-peer that routes calls to CallManager. Something like the following, where PBX phones would be calling 5xxx extensions on the CallManager at 1.1.1.1

!

dial-peer voice 3100 voip

destination-pattern 5...

session target ipv4:1.1.1.1

dtmf-relay h245-alphanumeric

fax rate disable

no vad

!

If it's MGCP, is the gateway configured with an appropriate CSS?

181
Views
0
Helpful
1
Replies
CreatePlease to create content