Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Call is not RONA to available agent

I have two agents both in Ready, call rings in and Agent 1 does not answer causing a RONA but Agent 2 never gets the call.  The will ring then disconnect.  Has anyone seen this behavior before? If so what is the fix?

2 REPLIES
Green

Re: Call is not RONA to available agent

That was pretty brief.

Let's try this check list. Tell me how each of these tests goes.

1. Agent1 not ready, Agent2 not ready, call arrives and is queued. Agent1 goes ready and answers the call. ???

2. Agent1 not ready, Agent2 not ready, call arrives and is queued. Agent2 goes ready and answers the call. ???

3. Agent1 not ready, Agent2 not ready, call arrives and is queued. Agent1 goes ready, does not answer, and the call RONAs and Agent1 is made not ready. Agent1 goes ready and gets the call. ???

4. Agent1 not ready, Agent2 not ready, call arrives and is queued. Agent2 goes ready, does not answer, and the call RONAs and Agent2 is made not ready. Agent2 goes ready and gets the call ???

5. Agent1 not ready, Agent2 not ready, call arrives and is queued. Agent1 goes ready, does not answer, and the call RONAs and Agent1 is made not ready. Agent2 goes ready and gets the call. (you said this fails).

6. Agent1 not ready, Agent2 not ready, call arrives and is queued. Agent2 goes ready, does not answer, and the call RONAs and Agent2 is made not ready. Agent1 goes ready and gets the call ???

Regards,

Geoff

Re: Call is not RONA to available agent

Assuming ICM, post a screenshot of the queueing piece of your ICM script, it's possible that you might not be re-queuing the call once it RONAs.  Also, what Geoff said.

david

183
Views
0
Helpful
2
Replies