I´m scripting callflows for our customer. The main callflows works. During a menu the caller press a digit and comes to subflows. The subflow standalone works also ok. But when I press3 during the menu, the call disconnects without going to the subflow.
If I use a callredirect to a trigger with the subflow it works without any problems.
I'm pretty new to CCX, but I've run into this with menu's when I forget to associate a connection with a dtmf digit. In the menu properties on the 'filters' tab, select the connection and make sure your digit (looks like 3) is also selected. What it sounds like is happening is that no connection/branch is being taken so it times out. You can verify also by doing something (I use play prompts as a quick and dirty troubleshooting method) under the timeout or unsuccessful conditions to pinpoint where the problem is. Others on the forum seem to prefer the reactive debug as a go-to troubleshooting mechanism but to each his own.
You are not providing enough information..during the debug, when the session arrives at the SubFlow Step what happens? Does the Script "throw" and Exception? What is the Exception? Does it move past the step with no results as you are saying in the SubFlow? You really need to provide more details..
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...