caller doesn't hear a ring back if the call is ringing on agent phone
can anybody help me? Here in Germany there are a lot of customers that don't understand why the caller doesn't hear a ring back when the call is ringing on agent phone for instance with UCCX 8. I read some discussions here for that issue but the only solution for that should be to change the MOH on CUCM. This is not a very good solution when the call in queue is set to hold he will hear the ring back tone in the queue as well :-(
Has anybody another solution for that issue???
All the discussion I've read was for IPCC version 4 or so. Is there another solution for this issue in version 8.x
In one discussion I found the following solution:
Yes, To resolve this issue,Set up a Send H225 User Info Message service parameter for Cisco CallManager service in CallManager. Perform the following steps:
In Cisco CallManager Administration, select Service > Service Parameter.
Select the correct server from the drop-down list.
Set the service to Cisco CallManager.
In the Send H225 User Info Message field, under the Cluster Wide Parameters (Device - H323) section, select H225 Info for Ring Back.
Reset the H.323 voice gateway.
After completing this procedure, the caller hears ring back when the agent phone is ringing.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...