Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Caller NAME presentation on PRI - H323 G/W

I had a QWEST PRI and had Caller ID and NAME being presented.

I changed it to an AT&T PRI and I have the Caller ID displayed but NOT THE CALLER NAME.

I can see the Caller NAME in the debug isdn as a FACILITY IE message and QWEST was sending as a DISPLAY IE message. I called AT&T to check if they can send as a DISPLAY IE but they say they CANNOT. Has anybody got this done by AT&T / Bellsouth / SBC.

I cannot change it to MGCP as it is a PARTIAL PRI.

I already checked

http://www.ciscotaccc.com/kaidara-advisor/voice/showcase?case=K14016668

1 REPLY
Community Member

Re: Caller NAME presentation on PRI - H323 G/W

I have the debug from QWEST (Previous vendor) and AT&T the new vendor in the attachment.

Is there a TCL script or something that can modify the field form Facility message to a Display ie.

135
Views
0
Helpful
1
Replies
CreatePlease to create content