There is a Sub-Menu in the flow where the user has to enter TPIN. User gets 3 tries, if unsuccessful, it goes back to Main menu.
NOW I have used a count element (Initial=0, step=1) to do this. The the problem is, when the retries are over, the Count Value does not reset to 0. it stays 3. If user comes back to this menu, user gets only 1 try, as the Count element value does not reset and starts from its last value (ie from3, then goes to 4, then increases for each attempt in this menu).
I need to set the value of this count element to 0 when ever this subMenu is accessed. I dont want to write a class or code for this.
Is there a simpler way to do this, to set this count element data back to 0?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...