Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Cannot add local static routes in CVP Ops console

Dear all,

I have installed the CVP 9.0 components and I am now in the phase of configuring the Call Server via the Ops Console.

I have already added the call server, but when I'm trying to configure the SIP subsystem, the Local Static Routes buttons (Add and Remove) are grayed and I am not able to add any route.

Kindly, is there any missing step that I should have done before adding a route?

Any help would be greatly appreciated.

Thank you in advance.

 

 

6 REPLIES
Community Member

 When you say Local Static

 

When you say Local Static Routes do you mean Dial Number Patterns?

Also on the Call Server - SIP Tab -are the Use DNS SRV and Resolve SRV localy checked & enabled?

Kartik

Community Member

 Also, have you added any

 

Also, have you added any CallManagers or Gateways to CVP OpsConsole yet? As I believe only they can be pointed to by a static route.

Kartik

Cisco Employee

Hi, Enable Override System

 

Hi, 

Enable Override System Dialed Number Pattern Configuration check box under sip tab, then Add and Remove buttons gets enabled. Please see the attached document.

 

Thanks,

Sasikumar. 

Community Member

Thank you Sasdivve for the

Thank you Sasdivve for the help

Best Regards,

Cisco Employee

is the issue resolved

is the issue resolved Laranoueir ?

Thanks,

Sasikumar.

Community Member

Yep :) Thank you

Yep :) Thank you

189
Views
0
Helpful
6
Replies
CreatePlease to create content