Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cannot delete call type

Hi All,

I am note able to delete call type in configuration manager of ICM, i'm getting the following error:

The call Type cannot be deleted because it is referenced by a script

i have used the search tool of the script editor to see if it is used by any script, but was not able to find any.

Any advise?

Thanks,

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions
Green

Re: Cannot delete call type

1. Go into Config Manager, Deleted Objects - any scripts there? If so, permanently delete all scripts. Find in the Script Editor only searches active scripts.

2. Use the Config Manager tool Script Reference and cross check the call type references using that tool. You may have it in an inactive script. If so, delete all those old copies and then permanently delete them.

3. Try again.

Regards,

Geoff

4 REPLIES
Green

Re: Cannot delete call type

1. Go into Config Manager, Deleted Objects - any scripts there? If so, permanently delete all scripts. Find in the Script Editor only searches active scripts.

2. Use the Config Manager tool Script Reference and cross check the call type references using that tool. You may have it in an inactive script. If so, delete all those old copies and then permanently delete them.

3. Try again.

Regards,

Geoff

New Member

Re: Cannot delete call type

Thanks Geoff, straight to the point as usual

New Member

Hi, 

Hi, 

We have a request for deleting some set of flows as that is no longer required, we are planning to delete Call Types, Skill Groups, DNs along with Scripts. 

Will that cause any data missing when we pull Historical report fr the same?

Please advise

Hi Hari, 

Hi Hari, 

you won't be able to pull the report from CUIC if you permanently delete it from Miscellaneous Tools>> Deleted Objects. 

if you just delete (call types, Skill groups or DN's) , you are still able to get historical reports from CUIC since the value list (collection) still hold these deleted items. but if you do the permanent delete from deleted objects, you will not be able to get the reports from CUIC and you may need to run from ICM DB based on the skill target ID/ Call type ID , Dial number ID ( the primary key of the each table) to get the historical records. 

I hope it helps you... 

735
Views
0
Helpful
4
Replies