Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CCM LDAP Server information

Hi, I have successfully installed IPCCE co-resident with CCM4 but when running the initial setup and after entering the LDAP server info, I don't see anything come up in the user management page. I assume that I am not entering the correct LDAP info.

This is the info:

Select LDAP server Type=====Active Directory

LDAP server host name=====192.168.1.50 "MS AD installed on windows 2000"

LDAP server port*======389

LDAP administrator username*=====cn=Administrator,ou=Users,dc=hadi,dc=com

LDAP administrator password*===password

User Base location*=====ou=cisco,dc=hadi,dc=com

Cisco CallManager Base Context*=====ou=cisco,dc=hadi,dc=com

Any suggestion based on the above config?

3 REPLIES

Re: CCM LDAP Server information

If the credential you are providing is wrong, you should get a error prompt that it can't access the CCM ldap. Do you get the same? Or you can see the blank white page only, if so, restart the processes.

Hope this will help.

New Member

Re: CCM LDAP Server information

Hi, Thanks for the reply, there was an issue with the info I was entering and it is fixed now.

I have another problem where the JTAPI service doesn't start, I have the trigger, route point and CTI ports configured but the JTAPI Subsystem doesn't start. In the CM the route point gets registered but the CTI ports don't. They are correctly associated with the respective users.

Re: CCM LDAP Server information

If the CTI route point is associated with an IPCC Express trigger, and the script that trigger fires isn't valid (i.e. doesn't pass the validation test in the CRS Application Development environment), then you'll see that behavior. Once the script problem is fixed, it should come up.

237
Views
0
Helpful
3
Replies
CreatePlease login to create content