06-23-2016 06:29 AM - edited 03-14-2019 04:16 PM
Hi Folks,
We have CCX 10.6.1 with Finesse. One of our newly added supervisor is not able to perform Silent monitoring while other supervisors are working fine on other extensions.
On Finesse it gives us the error Agent Device does not support Silent Monitor CTI Error= 88407. While other supervisors can silently monitor the same agent.
Check the attached screen shot for reference.
Thanks in advance.
06-23-2016 11:02 AM
Hi,
Below points to be applicable for new supervisor Phone configuration .
--Phone BIB ( build in bridge ) should be on
--Supervisor and Agent Phones are in same Partition
--Supervisor – line Monitoring CSS need to be assign
Check the supported phones model for silent monitoring for version 10.5.6 .
If above setting are in place , please remove the new supervisor from Members and supervisor list and add it again .
Ramamoorthy.S
06-26-2016 01:40 AM
Hi Ramamoorthy,
All mentioned above steps have been taken before and checked but the result is same. Even I have removed and added the user from supervisor and member list but no use.
Phones is supported with SCCP for finesse 10.6.1.
06-23-2016 10:28 PM
Refer to below post and verify the settings again:
https://supportforums.cisco.com/discussion/12727356/uccx-106-silent-monitor-generic-error
Regards
Deepak
01-29-2020 05:17 AM
HI Sheraz
I have the same problem. In my case the same Supervisor can silently monitor to some agents and no others.
CCX 11.6 and IPCC.
TIA
Cristian
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide