I'm trying to setup a CCX HAoWAN deployment but I'm findind some problems trying to add the second node to the cluster.
The servers are installed in different sites and with different subnets. When I try to add the second server to the cluster (in the Replication Wizard step) I get this error:
Add to Cluster is failed because of ClusterException Timeout for Node Controller 1 : AddToCluster
The only packets denied by the firewall are multicast packets sent from the second node (right now I’m not sure about the destination address, 22.214.171.124 or 126.96.36.199) and I suppose these packets are sent from the Jini lookup service used by the MCVD. I haven’t found any documentation about this requirement (multicast allowed through the WAN). This is the only reason I have found that could explain the error.
Any idea on how to solve this problem? Have you ever faced this problem (maybe it's not because of the multicast traffic blocked in the fw...)?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...