Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CCX5.0(2) - Initial Setup of CRS

Hi!

When performing first node setup procedure, after filling in the Unified Configuration Page, the Systems Parameters Configuration page does not open (it appears done at the bottom but it's all white).

What could be the problem?

Best Regards,

Ana

5 REPLIES
New Member

Re: CCX5.0(2) - Initial Setup of CRS

Not sure - browser type ?

New Member

Re: CCX5.0(2) - Initial Setup of CRS

Hi!

The browser is Internet Explorer 6.0.3790.1830

New Member

Re: CCX5.0(2) - Initial Setup of CRS

Hi,

I have the same problem, using CRS 5.0(2) fresh out of the box, installed the system by the book.

Did you get a solution for this problem?

I urgently would like to know what the problem was?

Thanks in advance,

Chris

New Member

Re: CCX5.0(2) - Initial Setup of CRS

Hi!

Check licenses and make sure the AXL service password is the same used in the CM.

Best Regards,

Ana

New Member

Re: CCX5.0(2) - Initial Setup of CRS

Thanks for the reply.

I managed to use another customer's lcense just to prove this, based on another thread I saw. This was indeed the case. I had to go to TAC for a license in the end as the one I had was not working.

They came good and everything sprang into life.

Thanks,

Chris

168
Views
0
Helpful
5
Replies