I think that I need to use CET to export my current lics (UCCX 7.0) so I can install them on the new 9.0 system but, and I realize this may be stupid but will export essentially give me a "copy" of the license file or will it remove the license from the server. I cannot have the latter as we have not converted to the new system yet but my temporary licenses are about to run out.
Your UCCX 7 licenses will do exactly 0 good on UCCX 9. Where would you get this idea? You need to run the upgrade through proper channels, the PUT tool. Assuming you've done this, assuming your customer has paid for licenses and for whatever reason you have elected to not get production licenses, then you can have the customers AM instruct licensing to issue an extension.
The whole situation however doesn't make a lick of sense.
I was told that what I needed to do was order the 7.0 to 9.0 upgrade from PUT which I did. I was also told that when I installed that license file, it would convert the 7.0 licenses to 9.0 licenses but I had to install the 7.0 licenses on the new server after I install the 9.0 upgrade file so that is why I need the 7.0 license files.
As for not making a lick of sense, that is about right when it comes to Cisco licensing and the ensuing confusion.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...