Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

change the default CoS 5 for voip

hi i was looking for a way to change the cos 5 for an Ipphone to 6 , which is connected with a pc to the secondary port and keep the cos 3 for the pc frames. the switch its a 3548XL.

thanks

1 REPLY
Hall of Fame Super Silver

Re: change the default CoS 5 for voip

You should never change it to COS as that is used by routing protocols, and typically does not have higher priority. With QoS you can prioritize any traffic you want and it's not really dependant on the COS value. How do you figure the PC is using COS 3, are you overrriting it on the NIC card?

Here is my recommandation based on Cisco best practices: Leave RTP traffic at 5, voice signialing at 3, all best effort traffic at 0.

Alos, I dont belive 3548 can do much LAN QoS anyhow...

Good reading is QoS SRND at:

www.cisco.com/go/srnd

HTH, please rate all posts!

Chris

361
Views
3
Helpful
1
Replies