Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Changing IPCC X 4.0(3) prompts from G.729a to G.711?

When installing IPCC Express 4.0(3) it asked if I wanted to use G.729a or G.711. I selected G.729a and now want to change my mind. I've re-configured my scripts to use prompts with G.711, now how do I change IPCC to have prompts use G.711?

1 REPLY
Blue

Re: Changing IPCC X 4.0(3) prompts from G.729a to G.711?

Hey jason,

you have to re-run the setup (so insert CD1 and run through the install again). You won't lose any data by re-running setup but I would still recommend taking a good BARS backup to be safe.

Look for this paragraph in "Changing Installation Information After Installing" section at this link:

http://www.cisco.com/univercd/cc/td/doc/product/voice/sw_ap_to/apps_4_0/english/administ/crs404ig.pdf

"Perform the Cisco CRS installation

procedure, entering new information as

needed. See the ?Installing the Cisco

CRS Software? section on page 5-3."

please rate helpful posts.

adignan - berbee

127
Views
0
Helpful
1
Replies
CreatePlease to create content