We are currently running an IPCCE 6.0 setup with CCM(Ver.4.1(3)) and two IP-IVR's (Ver 3.5). In this setup both the IVR's in Directory setup have the address od CCM-PUB configured as the Directory HostName. My question here is that can we change the address to CCM-SUB in Directory HostName config and what will be the impact of doing so ?
Host name or IP address of the Cisco IP telephony directory server where the profile resides or where it will reside with the CRA Engine profile. The information entered in this field should be consistent with the information entered in the CTI Manager Area on the CTI Manager Locations pane during CRA installation
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...