Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco CTI Server Timeout for IPPA

I am usinf CUCM 8.0.2 and CCX 8.0.2 with Premium License.  While attempting to log in an agent using either CAD-BE or IPPA, a message is returned as follows: “Your request to the Cisco CTI server timed out.  Try again.”  User 'telecaster' is configured with the 'Standard CTI Enabled' group, agent phones are associated with the 'telecaster' user, and agents are properly configured in RmCm.  Anyone else seen this problem?  Both of my machines are running in VMWare.  Any help is appreciated...

Everyone's tags (3)
5 REPLIES
Cisco Employee

Re: Cisco CTI Server Timeout for IPPA

Hi smfoy,

Is CUCM also AD integrated? CAD or IPPA send a authentication request to CUCM. If the timer set for CAD and IPPA (10 seconds) expires then the error will appear. More than likely the fix is at the CUCM. Please see the attached tech note regarding the timeout observed.

Regards


Joe

New Member

Re: Cisco CTI Server Timeout for IPPA

Hi. Was wondering if you figured out the issue that was causing the timeout error. I'm going through the same problem on a new install on the same version you listed here. However, my CUCM is not linked to AD, so technically this should not be happening.

Any help would be much appreciated.

Thanks,

Nelson

New Member

Re: Cisco CTI Server Timeout for IPPA

For me, the issue was related to my Virtual Machine's Processor setting.  I had 2 Processors assigned to Unified CCX in VMWare, and this caused the machine to run very slow.  After changing the Processor setting to 1, the issue was resolved.  Best of luck.

Steve

New Member

Cisco CTI Server Timeout for IPPA

That issue is generaly caused by a network issue.

Check your UCCX and cucm DNS name resolution.

Be sure that your DNS is reachable.

Add your server on your DNS AND in the dns reverselookup zone.

Configure ip adresses in the CUCM  (system config cucm)instead of names.

mat

New Member

Cisco CTI Server Timeout for IPPA

It wasn't a network/DNS issue. It turned out to be a compatibility mismatch between CUCM 8.5 and UCCX 8.0.2 I had it on SU1, had to bring it to SU2. Problem solved.

2288
Views
0
Helpful
5
Replies