When an IP Phone agent chooses this service, CallManager provides a prompt for the agent ID, password, and extension. Add an additional IP Phone Service just for one button login with a slightly different URL (http://xxx.xxx.xxx.xx:yyyy/ipphone/jsp/sciphonexml/IPAgentLogin.jsp) and add parameters for the ID, password, and extension in order to implement this procedure. You want two IP Phone Services set up so if an agent has a problem using the one button login service (i.e. because the password was changed), the agent still has the regular IP Phone Agent service to use. Note that one button login service should only be used for initial login. Once the agent is on non-IP Phone Agent screen, the regular IP Phone Agent service should be used to get back to the Skill Statistics screen and other IP Phone Agent screens. When the IP Phone Service is added to each agent phone, specify the values of these parameters. The procedure in this section assumes that you are creating the additional one button login IP Phone Agent IP Phone Service from the start. If the one button login IP Phone Agent Service is already created, skip to step 12.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...