I am developing a interface between the IVR and an application server. I created a custom class that uses proprietary files to communicate with the application server. That is working pretty well. I then added my custom class in UCCX, that worked well. My problem is that UCCX doesn't know where to look for the proprietary files (a jar file) so it's raising an error that the class isn't found. (In windows this is done using the environment variables CLASS PATH).
Where can we modify the default class path of the UCCX so that it points to that jar file?
I'll assume that you are using a 5.x or higher version of UCCX.
Upload the jar or class files to the classpath folder using the document management page of appadmin. You can then go to the custom file configuration section in appadmin and move the period(.) from Available to the Selected section.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...