I have a IPCCX 4.0.3 deployed, and recently - we have upgraded it to a HA deployment. Now, the problem is that the cluster reports Partial Service as the VOIP Monitor Subsystem is in Partial Service. Any advise on how I should go about this?
Secondly, I also realised that the Application Manager is in its Shutdown state at the Publisher where as the Subsriber shows that it is IN Service. Is it suppose to be like this or something somewhere went wrong?
Re: Cluster in Partial Service after HA deployment
The router shelf I/O controller card and network processor card are required system components. The system cannot operate unless the I/O controller card and network processor card are installed properly; however, the system can operate without any port adapters installed as long as none are in partial contact with the midplane pins. A port adapter that is partially connected to the midplane causes the router shelf to crash or to hang. Therefore, first ensure that the I/O controller card and the network processor card are installed properly and that the system software has initialized successfully. Then, if necessary, you can troubleshoot individual router shelf port adapters, dial shelf controller cards, modem cards, or trunk cards
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4