Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Configuring HA

I'm looking for some help with getting HA correctly configured. I'm running ipccx 4.0(1) HA at a remote site with a local ccm 4.1(3)sub. My question is about the jtapi provider addresses and the CCM group that the CTI route points and ports use. So far, it looks like the 2 jtapi providers need to be the same CCM servers listed used buy the devcie pools of the jtapi devcies. I'd point to the remote pub and local sub. Has anyone gotten this to work?

Thanks in advance.

1 REPLY

Re: Configuring HA

For jtapi, you may use sub first and then pub

For ldap you should have it other way round.

HTH

122
Views
0
Helpful
1
Replies