CRA 3.5(3) environment. Active Directory Setup, pointed to Sub first, Pub second. When we pull the Sub, failover does not work. The Pub registers all of the IP devices except the IVR functionality. IVR cannot talk to the Pub Directory. IP addresses on same subnet and both ip addresses are configured under Subsystem Jtapi and ICD configuration.
Backup utility puts out a warning that Publisher is not integrated with DC Directory, but we are using AD.
Yes..This is very helpful. It looks like much effort. I wish I could just add the secondary IP address under Configuration & Repository and cycle the Engine and it would work. Would make my life much easier...ha.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...