Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CRA - Maximum executed steps

I am getting this exception in CRA 3.5(2) and would like to increase the value from the default 1000 steps. My concern is the CRA online help as well as documentations states that the default value should not be changed. Would appreciate it if someone could point out the implications of increasing this value, and how much should I increase it by, e.g. increments of 500, 1000, etc.

Thank you.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: CRA - Maximum executed steps

It is adjusted under System\Engine\Engine Configuration\Maximum Number of Executed Steps

The caveat is that you should know why the 1000 step value is being exceeded. This parameter is a safety mechanism that prevents scripts from falling into endless loops.

It may be that you have huge script that should require >1000 steps. If not, you may have some bad logic that loops unnecessarily.

If, after evaluating your application, you determine that it is appropriate to exceed 1000 steps, adjust the value to be just large enough to accomodate your application. The particular value will vary.

Let me know if this helps by rating the post.

Michael

2 REPLIES

Re: CRA - Maximum executed steps

It is adjusted under System\Engine\Engine Configuration\Maximum Number of Executed Steps

The caveat is that you should know why the 1000 step value is being exceeded. This parameter is a safety mechanism that prevents scripts from falling into endless loops.

It may be that you have huge script that should require >1000 steps. If not, you may have some bad logic that loops unnecessarily.

If, after evaluating your application, you determine that it is appropriate to exceed 1000 steps, adjust the value to be just large enough to accomodate your application. The particular value will vary.

Let me know if this helps by rating the post.

Michael

New Member

Re: CRA - Maximum executed steps

I was testing out a scenario whereby a caller would choose every posible option in the IVR menu over and over again. Would like to know whether it is posible to catch this exception in ICM so that the system is able to play an appropriate prompt saying that it has reach a maximum number of attempts.

Thanks in advance.

131
Views
0
Helpful
2
Replies
CreatePlease to create content