Creating and Reading a variable from multiple scripts
I am creating a series of scripts for our help desk and one of the things we are trying to do is to play critical outages for users when they dial in to the system prior to being put in queue. However we want to be able to turn this on or off depending if there are any outages.
I have the help desk record outages in a script and I also give them the ability to toggle a variable in this script as to whether the critical outage prompt should play or not.
The question I have is how do I read the value of that variable from my main script? What is the best way to accomplish that?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...