Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CRS 4.0(4) One button LOGOUT (not LOGIN)

Based on info in the URL:

http://www.cisco.com/en/US/partner/products/sw/custcosw/ps1846/products_tech_note09186a008029e6d5.shtml

we have set up a service for one button agent login. We had been using a one button agent LOGOUT with this URL:

http://x.x.x.x:6293/ipphone/jsp/sciphonexml/IPAgentStateChange.jsp?State=Logout

and since we upgraded to CRS 4.0(4) from 3.5(4), this URL no longer exists and the IP Phone gets a HTTP 404 error.

Can anyone tell me the updated URL for a one button LOGOUT for 4.0(4)? Thanks.

2 REPLIES
New Member

CRS 4.0(4) One button LOGOUT (not LOGIN)

Hello,

I am trying to do the samething with UCCX release 9.0.  Finally, did you find the solution ?

Thanks

New Member

CRS 4.0(4) One button LOGOUT (not LOGIN)

Ok this is the good URL addresses  UCCX release 9.X

One button loggin

http://xxx.xxx.xxx.xxx:6293/ipphone/jsp/sciphonexml/IPAgentLogin.jsp

With parameters (refer to : http://www.cisco.com/en/US/products/sw/custcosw/ps1846/products_tech_note09186a008029e6d5.shtml)

One button logout

http://xxx.xxx.xxx.xxx:6293/ipphone/jsp/sciphonexml/IPAgentChangeState.jsp?State=1

(no other parameters required, only the URL)

One button Ready

http://xxx.xxx.xxx.xxx:6293/ipphone/jsp/sciphonexml/IPAgentChangeState.jsp?State=4

(no other parameters required, only the URL)

One button Not Ready

http://xxx.xxx.xxx.xxx:6293/ipphone/jsp/sciphonexml/IPAgentChangeState.jsp?State=3

(no other parameters required, only the URL)

395
Views
0
Helpful
2
Replies