We're running CRS 5.0 with ICM and CUCM. I am unable to successfully refresh the database schema so that I can select a connection.
I have 3 total data sources configured in CRS Administration. I have an accompanying ODBC Data source configured for all three and they all test successfully. I am able to sucessfully connect to each of these data sources using a SQL client from our IP IVR box. I have also restarted the CRS Engine during my troubleshooting.
When I open a new or existing script, insert a Database Get Step, and hit the "Refresh Database Schema" button it just hangs for 30 minutes or more. I ultimately have to shut it down using task manager.
In my case the refresh was ultimately sucessful. I can't say for sure if the reboots, Engine restarts, or just patience are what corrected the issue. One of the datasources was a hefty Oracle database and I guess it just took some time to pull back the entire schema definition.
It all depends on how many data sources you have defined and the sizes of those datasources. I've seen it take upwards of 30 minutes in my environment. If it takes any longer than that you may want to consider turning up tracing and see if something has gone awry.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...