Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CRS upgrade failures

Has anyone successfully upgraded CRS from 3.5(4) to 4.0(4)? Also, when the upgrade fails and you try again, the installer says that the profile you need to use is already in use and it forces you to create a new profile. This isn't good since that profile that is "already in use" is the precise profile that I need to use for the upgrade. Does anyone know how to get around this problem? I'm thinking of reinstalling the current version and hoping to re-take the profile back and trying once again to go to 4.04.

1 REPLY
Silver

Re: CRS upgrade failures

Did you still have Cisco CRS CD 1 in cd drive? If yes, then check back to steps # 2 if the CRS Installation Wizard does not start

automatically.

the version of Call Manager/ Jtapi you need if you are going to upgrade your CRS to 4.0.4

CCM

4.1(2) - JTAPI 2.1(2.3)

SR1 - JTAPI 2.1(2.5)

4.1(3) - JTAPI 2.1(3.3)

- JTAPI 2.1(3.9)

SR2 - JTAPI 2.1(3.11)*

SR3a - JTAPI 2.1(3.14)

4.2(1) - JTAPI 2.2(1.5)

SR1 - JTAPI 2.2(1.5)*

100
Views
0
Helpful
1
Replies
CreatePlease to create content