Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CSQ Prompt

IPCC 4.0.4 I'm trying to understand if Create CSQ prompt step is related to the prompt parameter under the CSQ CRS web page and when I should use this prompt. Thank you very much.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: CSQ Prompt

Yes it is, and in fact when you specify which CSQ you want to retrieve the prompt from, you specify it with a String that represents that specific CSQ's ID.

How you get the CSQ ID is very easy, and there are many ways to do it.

I would suggest the following: (UCCX 5.x example)

In AppAdmin, under Subsystems > RmCm > Contact Service Queues, click on the CSQ you want to obtain the ID for, then look at the URL.

The CSQ ID should be obvious at this point.

Here is an example URL: http:///appadmin/ICD?request_type=csd.configure&csdid=1

The resulting CSQ ID is 1, as seen in that example.

So your Contact Service Queue field should be a String of the integer 1 (e.g., "1").

Screen shot attached.

** This reply was simply because I hate searching the forums, and finding my exact problem, with no resolution.

Anthony

Anthony Holloway

Please use the star ratings to help drive great content to the top of searches.
1 REPLY

Re: CSQ Prompt

Yes it is, and in fact when you specify which CSQ you want to retrieve the prompt from, you specify it with a String that represents that specific CSQ's ID.

How you get the CSQ ID is very easy, and there are many ways to do it.

I would suggest the following: (UCCX 5.x example)

In AppAdmin, under Subsystems > RmCm > Contact Service Queues, click on the CSQ you want to obtain the ID for, then look at the URL.

The CSQ ID should be obvious at this point.

Here is an example URL: http:///appadmin/ICD?request_type=csd.configure&csdid=1

The resulting CSQ ID is 1, as seen in that example.

So your Contact Service Queue field should be a String of the integer 1 (e.g., "1").

Screen shot attached.

** This reply was simply because I hate searching the forums, and finding my exact problem, with no resolution.

Anthony

Anthony Holloway

Please use the star ratings to help drive great content to the top of searches.
189
Views
0
Helpful
1
Replies