CTI route point, though registered in CCM not working
In CCM 5.1, we came accress the problem that though CTI route point was registered in CCM, on dialing the CTI route point from the exension, it was either giving busy tone OR system error message. However we were able to dial the CTI port number. The issue was not resolved even after restating CCM servers. What could be the root cause? from where can we find the logs for the same?
Re: CTI route point, though registered in CCM not working
I have the exact same problem with CTI Route Points and the same version of CCM 5.1.3
Is this an identified bug?? How can I debug CTI Route Point problems??? I have both IP Phones and CTI Route Points on the same partition "Internal" and the same CSS with this partition added to it. Actually the CTI RP worked at first but it suddenly stopped functioning.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...