Do a netstat -an on your box and see if anything is listening on port 42027. If there isn't then I would re-reun setup on your CG and make sure that the right port number was entered for the CG to listen for a CTIOS connection.
Just another thought....make sure that you have installed the JTAPI version that is from your CCM that you are connecting to. Also, I noticed that you have 2 PG's on this box. Make sure that your CG# matches the PG# of the agent PG and not the VRUPG (e.g if CCM PG is PG1 then CG is CG1...same if it is PG2, CG is CG2 even if you don't have a CG1)
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...