Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CUCCX 5.0(2) change clusters

Hello,

I have two CUCCX 5.0(2) clusters homed to the same CUCM cluster.   I'm in the process of moving all scripts, prompts, agents, etc off of our old UCCX cluster and onto a newly built cluster.   Most of these users are using CAD.   My question is, what is the appropriate method of changing CAD on cut over day to point to the new cluster.   If at all possible, I would prefer not to have to re-install CAD on each agent's desktop.   Is there a CAD file I can edit on their PCs?   I'm also unclear if reinstalling CAD will work anyways because I believe the CAD files don't get removed from the PC during an un-install but I could be wrong.   I suppose my question also includes the correct procedures for the Supervisor desktop as well.

Any help would be appreciated.

Thanks,

Glenn

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Super Bronze

Re: CUCCX 5.0(2) change clusters

The procedure is the same for CAD and CSD. Within the install directory will be a postinstall.exe application. Launching it (with CAD/CSD closed) will allow you to specify new CCX server IP addresses of the new cluster.

The one caveat to be aware of is if the existing CCX cluster is at a newer patch level than the new one you are installing (unlikely) CAD/CSD will not downgrade to match the new cluster version. If the reverse is true (new cluster has a higher patch level) the CAD auto-updater will kick off an update. If this happens and you have to revert back for some reason, you may need to uninstall and then install the CAD/CSD application manually. I would strongly recommend ensuring both custers are on the exact same version, including service release.

Please remember to rate helpful responses and identify helpful or
2 REPLIES
VIP Super Bronze

Re: CUCCX 5.0(2) change clusters

The procedure is the same for CAD and CSD. Within the install directory will be a postinstall.exe application. Launching it (with CAD/CSD closed) will allow you to specify new CCX server IP addresses of the new cluster.

The one caveat to be aware of is if the existing CCX cluster is at a newer patch level than the new one you are installing (unlikely) CAD/CSD will not downgrade to match the new cluster version. If the reverse is true (new cluster has a higher patch level) the CAD auto-updater will kick off an update. If this happens and you have to revert back for some reason, you may need to uninstall and then install the CAD/CSD application manually. I would strongly recommend ensuring both custers are on the exact same version, including service release.

Please remember to rate helpful responses and identify helpful or
New Member

Re: CUCCX 5.0(2) change clusters

Cool.   Thanks very much for the response.

Glenn

191
Views
5
Helpful
2
Replies