Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CUCCX re-run

Hello Fellas!

how are you doing today? hope you are all doing well.I am labbing cuccx7 on vmware. did some integration with cucm7. now i wanna re-run initial setup again, i forgot to take snapshot from cuccx. how can I re-run initial config, or reset cuccx to factory defaults?

thank you very much in advance..

2 REPLIES
Super Bronze

Re: CUCCX re-run

Hi

See this post : https://supportforums.cisco.com/message/1044177#1044177

It describes how to use cet to set the appadmin setup wizard back to FRESH_INSTALL state which allows you to rerun the appadmin setup.

It doesn't clear out the scripts/apps/prompts or any other settings, it's principally to recover admin access and so on.

If you actually want to clear out all data, the only real way is to flatten the box (or just go through each admin page and delete things, and perhaps purge the historical data).

Regards

Aaron

Please rate helpful posts..

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
New Member

Re: CUCCX re-run

Don't forget to clear out any ports and users that were auto-created in CUCM as well.  Can't have those there when you start the setup wizard or the rmcm wizard.

193
Views
0
Helpful
2
Replies