I am trying to find the high water mark for where the 200 concurrent can access a CUIC server but what is the theorethical average query for each report user. Below is a snippet from 8.5 SRND that calls out a queue size but I am not sure if this number would be in reference to what I am asking for.
" Even though the queue is quite large (1600MB) - it is not unlimited, therefore, it is possible to fill up the queue especially during prolonged failure. As the buffer fills and starts to reach capacity, an alarm will be sent (CiscoAlarm30) notifying administrators of the potential buffer exhaustion condition. "
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...