We a building custom reports using "Anonymous Block" as Data source, which is havingonly one parameter( of valuelist type.) But the problem we are facing is it shows a data picker in the Parameter Dialog apart from the value Listwhereas we do not have parameter of that type in this report.
Even we tried to dropping and recreating the reports and no use.
Another issue is, if we have parameter of type varchar in that case the results are not as expected, whereas if we change the parameter to int it works as expected.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...