I have CUOM 2.2 and I am not able to see the specific SNMP MIB of the UCCX, I can only see the generic OIDs (MIB2). I have enabled the SNMP windows service and configured the communities. Is there anything else I have to do? In Unity for example it is necessary to install the RSK to view the full CISCO MIB, is there anything similar for the UCCX?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.