I have a script that looks at the "Current Wait Duration from the Overall IPCC Express" statistic. For some reason, when it does that step, it always returns a -1 to the integer that holds it. I have tried it with the same setting for the CSQ, and it reports the proper time in seconds, but this one doesn't work. Unfortunately, the script can move the contact to a few CSQs before it is done, so I really need the Overall, not the CSQ statistic.
Has anyone used this stat before and can think why it would be returning the -1 (which must be an error) to it?
I believe your on the hunt for the lockness monster!
In most contact centers, it would never be a metric that would be needed, and honestly could never be a useable or accurate method of judging wait duration. For this reason, i would take a pretty good bet that your not going to find a way to recover this metric naturally.
The best answer would be to get the Wait duration of every queue that the call could possibly queue to, and if you want to be daring, go with the low number or and average of the queues, and if you want to be safe go with the high number.
Your really looking for an inverted estimate wait time calculation, and there is formula's for that all over this forum.
I may be way off base here but i think i remember doing a lab in this from the UCCX course. Like i say im not 100% but i think the lab was setup that if the value returned was -1 the prompt was "expected wait time is less than a minute". For a value of 1 was "wait is 60 sec".
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...