I have a problem in a CVP (VXML server standalone model) setup. The setup consists of a gateway (used both as PSTN and VXML gateway), a VXML server, a TTS server and an ASR server. Call scenario: When a customer calls, he listens to a welcome prompt (through TTS server) and then is asked to spell the called party's name and surname. The voice record will be passed to the ASR server and the corresponding DN will be returned to the gw. Then the call is routed according to the dial-peers.
The TTS integration works fine but no traffic goes to the ASR server. (we see nothing on a wireshark on the ASR server side)
I am not sure if some misconfiguration is causing this. Can you have a look at it?
(I attached the gw config, the vxml script i use and a debug taken from the gw.)
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...