After I moved my CVP servers and changed the IP addresses I am seeing the status of call servers as DOWN, even though I can control them and start/stop remotely from OAMP. I re-ran reimage.bat on the call servers as as well as reinstalled OAMP software and re-build the CVP device map. Has anyone run into this before?
I guess the only remaining thing is to uninstall and reinstall CVP call server, but I'd like to avoid that if possible.
Are the call servers actually running, or are they down because of wrong info in the configuration files? Can Calls be processed?
Also was secure communications turned on? If that was the case there is something in the troublehsooting guide about reseting this aswell in some of the call server conf files. I believe its in orm.conf or so...
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...