Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CVP Microapps-Concatenate Prompt on Menu

Hi- Does anyone know how to concatenate prompt using CVP 7.02 micro-apps. I am using the Menu step but I have 4 prompts that define that Menu step and need to combine them. I can use a third party utility to combine them but that will not be user friendly when customer wants to change these prompts. Please advise.

  • Contact Center
7 REPLIES

Re: CVP Microapps-Concatenate Prompt on Menu

I don't believe such functionality exists. However, you might be able to do this by using 4 menu microapps. The first 3 will have a wait for entry of 0 seconds while the last one can have a wait time of 3 seconds before it goes back to menu 1. Pretty much you're putting all 4 prompts in a daisy chain. After each menu you have a CED for all possible options. Hope this makes sense.

david

Green

Re: CVP Microapps-Concatenate Prompt on Menu

I agree that this is not standard functionality.

You could have three PMs before the Menu but you would have to set barge-in on each of these. As soon as the caller enters a digit, the prompt stops and it carries the digit in the buffer through the next prompts until it hits a Menu type of microapp (the 4th prompt).

This is described on page 194 of the CVP 7 Config Guide. I've never tried it though.

Regards,

Geoff

Re: CVP Microapps-Concatenate Prompt on Menu

Geoff,

I can tell you from (a bad and accidental) experience, this functionality does work as you explain it.

Cheers,

Chad

Green

Re: CVP Microapps-Concatenate Prompt on Menu

Thank you, Chad.

Regards,

Geoff

New Member

Re: CVP Microapps-Concatenate Prompt on Menu

For the first three prompts (Play Media), ensure that the Configuration Parameters is set to "N" (without quotes), and just before the fourth prompt (Menu), place a Set node, and set Call.CallerEnteredDigits to "". We use this setup a lot in our environment without failure, and it sounds quite seamless.

Green

Re: CVP Microapps-Concatenate Prompt on Menu

Interesting. That's somewhat opposite to what I was saying - you have turned off "barge in". How does the caller interrupt the first (or second, or third) prompt?

Regards,

Geoff

New Member

Re: CVP Microapps-Concatenate Prompt on Menu

Geoff - You are absolutely correct. If the user wants to interrupt the first three, then they can leave the Config Settings NULL, and the CED will pass to the CED node after the last prompt.

372
Views
0
Helpful
7
Replies
This widget could not be displayed.