CVP not sending VRU leg back to correct VXML gateway.
I'm still having problems and cannot get this to work.
My production environment - I have
two CVP servers (CVP1A and CVP1B).
I have two VXML gateways(VXML1A and VXML1B).
Two cube gateways (Cube1A and Cube1B).
I installed and configured a co-res CubeVXML gateway (CVXML3). If I send calls from this gateway to CVP1A, Label is assigned as 38999 which sends VRU leg to VXML1A, if I send call to CVP1B, Label is assigned as 38998 which sends VRU leg to VXML1B.
I need calls that came from 3rd gateway CVXML3 to be labeled and sent back to CVXML3 for call treatment. HELP!!
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...