I am just trying to test CVP RONA, and I actually can;t get the call to RONA. The CM is set to 16 seconds, the agent desk setting is set to 16 seconds, and it just keeps ringing and ringing, any ideas?
I really like SIP compared to H.323. SIP Static routing is easy to do, and the redundancy is a bit strange. I see that as a big downfall having to rely on DNS in order to achieve SIP redundancy. The significant digits your used to setting in VBAdmin is a secret property in the sip.properties file, not listed in the call server page on OAMP. Also on CCM I am not sure whats the right way but I found that A.) even though the config guide says don't use an MTP on the SIP trunk in CCM you have to for DTMF relay. B.) CTI Route points don't seem to work very well, so I send my calls from CCM into the SIP Proxy before going to the call server if a call is initiated internally. This way CVP has full tracking of the call like if it were coming from the ingress gateway.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...