Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CVP Survivability.tcl Script

From what I have read in the CVP Config and Admin guide, it looks to me like the survivability.tcl script should have the ability to recover a call and forward it to an alternate destination in the event of a failure. I have implemented it as close as I could to the documentation but calls are still completely disconnected when I stop the PG or the combo box during a call.

Has anyone else out there had better luck? The script works for all subsequent calls, but any active calls are always dropped. Any help would be greatly appreciated.

2 REPLIES
Blue

Re: CVP Survivability.tcl Script

Can you post your IOS configuration?

New Member

Re: CVP Survivability.tcl Script

Here you go Andrew, I am sure I butchered this. For sake of this discussion, my CVP dialed number is 5000, running in comprehensive mode. I have attached a "Show Run" and "Show Ver". You will notice I have several dial-peers at the end of the dialplan that I have been using to test. Basically the best I have come up with is when I dial 5001 the tcl scripts tries the CVP script first and then it routes to a secondary number.

What I really need is for the script to take the call in the event of a PG or combo box failure and transfer to the number listed. Is this possible? Let me know if you have any questions. I really appreciate your help!

Nate

394
Views
0
Helpful
2
Replies