Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Dedicate E1 Channels for Inbound/Outbound

Hi

With a fractional PRI of 8 Channels, is it possible to dedicate 4 channels for Incoming only and 4 channels for outgoing only.

The Voice Gateway used would be 3845, with IOS version 12.4.

Can this be achieved using CUCM v7.

Thanks

2 REPLIES
Silver

Re: Dedicate E1 Channels for Inbound/Outbound

On E1R2 signaling, you need to configure 2 ds0-groups on the controller E1. By doing this, you will have 2 voice ports. Use one for inbound calls and the other one for outbound calls by matching numbers on the destination pattern and associate that call with the outbound voice port number.

New Member

Re: Dedicate E1 Channels for Inbound/Outbound

Also, can we have 4 Channels dedicated for 4 IP Phones only, such that no other overflow call comes on these 4 channels.

Thanks.

149
Views
0
Helpful
2
Replies