Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Delay of ready state after end call in IPCCX

When an agents ends a call, how can you make a delay on 10-15 secs before he appears as ready in the system?

1 ACCEPTED SOLUTION

Accepted Solutions
Gold

Re: Delay of ready state after end call in IPCCX

Hi,

You will have to set up in the CSQ configuration webpages (RmCm), for each CSQ you have set up in IPCCX, you have to check the 'Automatic Work' to 'Enabled' and the 'Wraup time' to 10-15 seconds.

Hope this helps,

Juan Luis

6 REPLIES
Gold

Re: Delay of ready state after end call in IPCCX

Hi,

You would set up a wrap-up time of 10-15 seconds. After that 10-15 seconds, the agent will be available agian.

Depending of the producto you are using, IPCC Express or Enterprise, this wrap-up state is configured in a different manner.

Hope this helps,

Juan Luis

New Member

Re: Delay of ready state after end call in IPCCX

What i got is IPCC Express

Gold

Re: Delay of ready state after end call in IPCCX

Hi,

You will have to set up in the CSQ configuration webpages (RmCm), for each CSQ you have set up in IPCCX, you have to check the 'Automatic Work' to 'Enabled' and the 'Wraup time' to 10-15 seconds.

Hope this helps,

Juan Luis

New Member

Re: Delay of ready state after end call in IPCCX

Thank you very much Juan Luis

Gold

Re: Delay of ready state after end call in IPCCX

Don't forget to rate helpful posts ;-)

Juan Luis

New Member

Re: Delay of ready state after end call in IPCCX

Way ahead of you ;)

Thanks again...

125
Views
0
Helpful
6
Replies
CreatePlease to create content