Hello, can anybody explain how desktop monitoring works with IP Communicator.
With any hardware IP phone I understand that in "Cisco CallManager Administration" we set the "Span to PC Port" and with this the NIC receive both VLAN traffic (Voice and DAta) and if it is configured to pass VLAN tags it gets all the RTP stream in the voice VLAN.
When we have IP communicators then, do we need to configure anything special? or only "Enable Desktop Monitoring" in "Cisco Desktop Administrator" and then the CAD gets te RTP stream directly from the IP Communicator software?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...