Inbound calls to a uccx script, coming from the PSTN, DTMF fails 80% of the time.
Scenario is this: A caller on the PSTN dials an auto attendant script configured on uccx. UCCX answers and plays a prompt. At a digit collecting step, the caller enters, for example, a four digit extension. When it fails, UCCX only collects the last digit, instead of all four.
1. If I am doing a realtime debug on UCCX, the script ALWAYS collects the correct DTMF tones.
Yep, JTAPI logs always show that the digits are received correctly. The versions appear compatible but I'm completely sure. Looks like TAC case time.You'll notice in the JTAPI logs below it is complaining of an invalid destination. On the same dialed digits a successful call doesn't say that. Might be worth a resync anyway.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...