Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

duplicate CTI RP and CTI ports

When going throught the CRSX wizard to create CTI Route Points and CTI ports I am getting twice the amount of CTI ports that I have requested. There are not error messages in event viewer and the wizard completes successfully. For instance, when I created CTI RP 8000 and CTI Ports of 8001-8002, when the wizard completes I have CTI ports of 8001-8004.

any ideas?

Thanks

1 REPLY
Cisco Employee

Re: duplicate CTI RP and CTI ports

Hi,

might it be a HA Deployment? If so it will create the second port for failover purposes.

regards,

Riccardo

129
Views
0
Helpful
1
Replies
CreatePlease to create content