From time to time my desktop gets into a mode in which the Editor will not connect to the Script Repository or allow Active Debug. If I go to the AppAdmin and click on a scipt it loads the Editor ad the Editor shows that I am connected. If I hit the Debug Active, the drop down boxes are empty. If I click Open and Script Repository, I can not get their! I have re-installed, rebooted and done the usual vaudeville act, but no change? Does this avery happen to anyone else?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...