Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Green

EMSMON - does this only work against PG processes

UCCE 8.5(3)

With the loss of the process windows on Windows 2008 installs, we are encouraged to use EMSMON, a utility that has always been there but one that was hardly ever used by customers and partners. The BU developers knew about it, and old time Geotel employees used it, but virtually no one else did.

Now I have no problem with EMSMON against processes running on a PG: the Agent PIM, JTAPI gateway, the CVP PIMs. and the CG process ctisvr, and even CTIOS. For example:

C:\icm\ip1>emsmon ip1 pg1a pim2

Events from May 18, 2012:

10:29:03 pim2     Trace: EMSServer connection established in node name: ip1\PG1A process: pim2 for user Administrator.

But I can't do this to Router processes, Logger processes or AW processes. The RTR process is the one I'm really interested in.

C:\icm\ip1\ra\logfiles>emsmon ip1 ra rtr

10:32:55 Trace: EMSRemoteOutput: Waiting for EMSServ pipe connection ip1\ra\rtrEMSPipe.

Is this by design?

Regards,

Geoff

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: EMSMON - does this only work against PG processes

Try

routera / routerb instead of ra / rb

loggera / loggerb instead of la / lb

and Distributor instead of dist

Brian

3 REPLIES
Silver

Re: EMSMON - does this only work against PG processes

Try

routera / routerb instead of ra / rb

loggera / loggerb instead of la / lb

and Distributor instead of dist

Brian

Green

EMSMON - does this only work against PG processes

I just tried all three and they worked perfectly. Thanks so much.

Regards,

Geoff

New Member

EMSMON - does this only work against PG processes

Geoff / All,

I am able to connect to the processes with EMSMON.

However, I cannot see any valid output.

Output is in HEX.

The error I am getting is below:

EMSFormatMessage failed: EMS Error.

FormatMessage for message id 21010003 failed. getLastError() returned 815.

Any ideas why?

I am running from the folder:

C:\icm\

e.g. EMSMON icm PG1A pim1

Regards,

Gerry

2012
Views
5
Helpful
3
Replies